M-10 Floating Pump Cat No: 655PUMP10

$1,500.00

M10 Floating Pumps The Sunmotor M-Series floating pumps offer simplicity and convenient solar pumping from surface water sources or springs. Features Low power requirements (400  watts) No electronics - connect directly to solar panels or batteries Fully submersible Easy to install Easy to move for rotational grazing No suction lines to prime No freezing damage Built-in overload protection Converts to automatic sump pump Fully serviceable M10 Performance with 400 watt Solar array (30-34 volts) Pump Head Vertial Lift Peak Flow Rate Typical output on a clear Day Meters Feet L/min US gpm Liters US gal 2 6.6 43.0 11.4 12,900 3,400 4 13.1 43.0 11.4 12,900 3,400 6 19.7 41.5 11.0 12,500 3,300 8 26.2 39.0 10.3 11,700 3,100 10 32.8 37.1 9.8 11,100 2,900 12 39.4 34.8 9.2 10,400 2,700 14 45.9 32.2 8.5 9,700 2,600 16 52.5 27.3 7.2 8,200 2,200 18 59 22.7 6.0 6,800 1,800 20 65.6 17.0 4.5 5,100 1,300 1. The M10 pump is designed to be powered by 400 watts solar array confinure4d to deliver 30 to 34 volt at peak power. The sup is connected directly to the solar panels. No controller or other electronic compibets are rquired of recommended. 2. The M10 Pump is supplied with 15 m of submersible cable. The positive + wire of the cable is red. It must be onnnected to the positive terminal of the solar array. The black wire must be connect to the negative terminal of the solar array. 3. To install an M10 system, system, simply connect the discarge hose to the pump, place the pump in the water and connect the cable to the Solar array. Water flow will begin as soon as there is sufficient sunlight guttubg the solar panels. 4. Do not run the pump dry.it requires water to lubricate the ceramic bearings. If the water supply is uncetain please spcifiy a dry-run protection swithc wich can be added to the pump during manufacutering.