Detection Systems PX 10 Transpointer Cat No: DSP10

A solution to determine start and exit points for your drilling/coring applications. The easy-to-read display shows wall thickness for selection of the proper bit. Applications Locates points through a floor or wall allowing holes to be drilled from either side. Has ability to measure wall and ceiling thickness on most materials (i.e. wood, drywall, block, concrete with or without rebar) for easy selection of the proper drill bit or core bit for the application. Features and Benefits Time & Cost Saving Eliminate time consuming procedures such as drilling pilot holes, manual measuring and "trial and error" measuring Reduce inconvenient overhead drilling by locating points through a floor or wall allowing holes to be drilled from any side Single person operation with use of adhesive putty Innovation Ability to measure wall and ceiling thickness on most materials (i.e. wood, drywall, block, concrete with or without rebar) Large display window for measurements Use of the slope adapter allows angle drilling and coring Durable Rubber casing protects against dust and is water resistant (IP 56 protection level) Description Item No. PX 10 Transpointer Includes tool, receiver, (2) hand straps, PUA 91 adhesive putty, PUA 92 adhesive strips, (2) 9 V alkaline batteries and operating instructions in an impact-resistant plastic tool box 00273123 PX 10 Transpointer Set Includes tool, receiver, (2) hand straps, PUA 91 adhesive putty, PUA 92 adhesive strips, (2) 9 V alkaline batteries, marker, PXA 70 slope adapter and operating instructions in an impact-resistant plastic tool box 00273125 Service Hilti Lifetime Service Model: 00273123, PX 10 Transpointer : $834.84 00273125, PX 10 Transpointer Set : $972.71